Turbosystems K26/K27 turbine housing for Audi 2.2T

Turbosystems K26/K27 turbine housing for Audi 2.2T

Upgrade for Audi 2.2 10V and 20V classic car engines. Our new bolt-on turbine housing is designed to replace original K26 / K27 turbine housing which is restricting power. Housing capacity increased from 6cm2 to 10.7cm2 while original 54.6mm turbine wheels can be used. Built from SS347 stainless steel to prevent cracking at high temperature. Upgrade helps to get higher power, torque and lower back pressure. Our turbine housing designed to work with following dimensions turbine wheels and shafts: Inducer Diameter: 64.4 mm ; Exducer Diameter: 54.6 mm ; Tip Height: 10.1 mm ; OE shaft & wheel numbers: 5326-120-5002 5326-120-5001

The part is intended for a clean and reliable turbo installation. Vehicle-specific products use the original connection points where applicable, while universal parts simplify a custom turbo build.

Technical details

• Upgraded compressor side
• Upgraded turbine side
• Balanced on VSR

Compatibility

• Audi 80 (1988-1995)
• Audi 100 (1989-1994)
• Audi 200 (1988-1991)
• Audi S2 (1990-1995)

Check dimensions, connections and fitment before ordering. Contact us if you would like help confirming the correct part for your setup.