MuchBoost BMW hybrid turbo, BMW 328d xDrive F30 (US Spec) (240–280 hp)

MuchBoost BMW hybrid turbo, BMW 328d xDrive F30 (US Spec), 240–280 hp

A bolt-on MuchBoost hybrid turbo for applications including BMW 328d xDrive F30 (US Spec), BMW X3 29dX F25 (US Spec). This upgrade is built for BMW applications and retains a clean, vehicle-specific installation.

The turbo is based on original Garrett housings. The upgraded compressor and higher-flow turbine sides provide considerably more capacity than the factory unit, while the housings are precision-machined for the new internals.

Depending on the selected version, the manufacturer rates the turbo for approximately 240–280 hp. Final output depends on engine condition, the fuel system, intake, exhaust, cooling and, above all, the ECU calibration.

An upgraded turbo always requires vehicle-specific ECU calibration.

Futurez imports MuchBoost turbochargers and works with the manufacturer in Finland. You get secure delivery from a Finnish seller, a wide choice of payment methods and help selecting the correct turbo version. Every purchase also earns F* Bonus points.

Versions and technical differences

240 hp version

This version is built for approximately 240 hp, with upgraded internals sized for this output level.

• Manufacturer-rated power potential approximately 240 hp
• Upgraded billet compressor wheel
• Larger high-flow turbine wheel
• Reinforced journal bearing system for higher boost
• Precision-machined compressor housing and seal plate
• Variable-geometry VNT system calibrated on a flow bench
• Turbo core is high-speed VSR balanced

280 hp version

This version is built for approximately 280 hp, with upgraded internals sized for this output level.

• Manufacturer-rated power potential approximately 280 hp
• Larger high-flow turbine wheel
• Precision-machined turbine housing

Common to all versions

• Original Garrett housings and actuator
• Compressor and turbine wheels are balanced separately, followed by high-speed VSR balancing of the complete core
• Required gasket set is included
• Bolt-on fit in place of the original turbo

Examples of compatible vehicle applications

• BMW 328d xDrive F30 (US Spec) – 180/187HP (MY 2011–2019)
• BMW X3 29dX F25 (US Spec) – 180/187HP (MY 2010–2017)

Engine codes

N47D20A

Before ordering, check the engine code and the identification numbers on the original turbo. If you are unsure about fitment, contact us with the VIN and the old turbo numbers and we will help verify the correct version.

Tip: Ask us for the gaskets, bolts, oil lines and other installation parts at the same time. A new turbo should not be installed with a restricted oil feed or leaking gaskets.

MuchBoost turbochargers carry a 12-month manufacturer warranty covering manufacturing and material defects. The warranty does not cover failures caused by external factors such as lubrication problems, unsuitable engine calibration or installation errors.