MuchBoost CFWA 1.2TDI hybrid turbo, Skoda Fabia II 1.2TDI (110–130 hp)

MuchBoost CFWA 1.2TDI hybrid turbo, Skoda Fabia II 1.2TDI, 110–130 hp

A bolt-on MuchBoost hybrid turbo for applications including Skoda Fabia II 1.2TDI, Seat Ibiza IV 1.2TDI. This upgrade is built for CFWA 1.2TDI applications and retains a clean, vehicle-specific installation.

The turbo is based on original Garrett housings. The upgraded compressor and higher-flow turbine sides provide considerably more capacity than the factory unit, while the housings are precision-machined for the new internals.

Depending on the selected version, the manufacturer rates the turbo for approximately 110–130 hp. Final output depends on engine condition, the fuel system, intake, exhaust, cooling and, above all, the ECU calibration.

An upgraded turbo always requires vehicle-specific ECU calibration.

Futurez imports MuchBoost turbochargers and works with the manufacturer in Finland. You get secure delivery from a Finnish seller, a wide choice of payment methods and help selecting the correct turbo version. Every purchase also earns F* Bonus points.

Versions and technical differences

110 hp version

This version is built for approximately 110 hp, with upgraded internals sized for this output level.

• Manufacturer-rated power potential approximately 110 hp
• Upgraded billet compressor wheel
• Larger high-flow turbine wheel
• Clipped turbine wheel helps reduce exhaust backpressure
• Reinforced journal bearing system for higher boost
• Precision-machined compressor housing and seal plate
• Variable-geometry VNT system calibrated on a flow bench
• Turbo core is high-speed VSR balanced

130 hp version

This version is built for approximately 130 hp, with upgraded internals sized for this output level.

• Manufacturer-rated power potential approximately 130 hp
• Larger compressor wheel
• Larger high-flow turbine wheel
• Precision-machined turbine housing

Common to all versions

• Original Garrett housings and actuator
• Compressor and turbine wheels are balanced separately, followed by high-speed VSR balancing of the complete core
• Required gasket set is included
• Bolt-on fit in place of the original turbo

Examples of compatible vehicle applications

• Skoda Fabia II 1.2TDI – 75HP (MY 2007–2014)
• Seat Ibiza IV 1.2TDI – 75HP (MY 2008–2017)

Related OE and turbo numbers

789016-5002S
789016-5001S
789016-0002
789016-0001
03P253019B
03P253019BV
03P253019BX

Before ordering, check the engine code and the identification numbers on the original turbo. If you are unsure about fitment, contact us with the VIN and the old turbo numbers and we will help verify the correct version.

Tip: Ask us for the gaskets, bolts, oil lines and other installation parts at the same time. A new turbo should not be installed with a restricted oil feed or leaking gaskets.

MuchBoost turbochargers carry a 12-month manufacturer warranty covering manufacturing and material defects. The warranty does not cover failures caused by external factors such as lubrication problems, unsuitable engine calibration or installation errors.